Miller - (903777022)

• Plasma cutter
• ICE-55CM machine-held torch with 50 ft (15.2 m) cable and remote pendant.
• Heavy-Duty work clamp with 50 ft(15.2 m) cable.
• 10 ft (3 m) power cord
• Extra consumables

• This unit can be powered by any Miller welding generator with power output of 8 KW or more, such as the Bobcat™ or Trailblazer®.

• Auto-Line™ automatically connects unit to any primary input voltage from 208 to 575 volts, single- or three-phase, 50 or 60 Hz.

• LVC™ line voltage compensation provides peak performance power under variable conditions (187 to 630 volts) for steady cuts and cleaner ending cuts.

• Power Factor Correction (PFC) uses input power more efficienctly, ultimately using less energy.

• Wind Tunnel Technology™ prevents abrasive dust and particles from damaging internal components.

• Fan on Demand™ cooling system only operates when needed, reducing the amount of airborne dust/dirt pulled through the unit.

• Can be powered by any Miller engine drive, with generator power (e.g. Bobcat™) or equivalent competitive equipment.

• Quick-connect torch offers a fast plasma torch connection and removal.

• Starts without high-frequency so it will not interfere with or damage controls or computers.

• Pilot Arc Switch The expanded metal mode allows operator to cut grates, chain link fence, and other perforated metals without retriggering the torch.

• Post Flow Cooling Circuit Protection to extend the life of consumables and the cutting torch is enhanced by our post flow circuit that provides cooling gas after you release the trigger.

Detailed specs for Miller

• Rated: 7/8 in (22mm)
• Quality: 1 in (25 mm)
• Sever: 1-1/4 in (32 mm)

• 208 - 575 V 1 or 3 Phase

• A 230 volt, single-phase 40 amp (min.) individual branch circuit. Three phase requirements vary based on input voltage.

• 6 CFM (170 L/min.) at 100 PSI (689 kPa)

• 55 A at 110 VDC, 50% Duty Cycle, 1-phase
• 55 A at 110 VDC, 60% Duty Cycle, 3-phase

• 86 lb (39 kg)

Resources for Miller