Miller Spectrum 375 Plasma Cutter, 115/230 V, 60 Hz - (903891)

• Plasma cutter
• ICE-27C hand-held torch with 20 ft (6.1 m) cable.
• Heavy-duty work clamp with 20 ft (6.1 m) cable
• 10 ft(3 m) power cord with 115 VAC, 20 A plug
• Extra consumables (3 electrodes, 3 tips, and 1 air fitting)
• Built-in gas/air filter and regulator

• Electronic Pilot Arc Controller automatically controls the pilot circuit, increasing productivity and extending tip life.

• Electronic Pilot Arc Controller automatically controls the pilot circuit to provide expanded metal cutting ability without having to re-trigger the torch, increasing productivity and extending tip life.

• Dual input voltage allow either 115 or 230 VAC input power and provides patented protection in case of incorrect switch position.

• LVC™ line voltage compensation provides peak performance power under variable conditions (98 to 132 volts) for steady cuts and cleaner ending cuts.

• Can be powered by any Miller engine drive with generator power (e.g. Bobcat™) or equivalent competitive equipment.

• Power factor correction uses input power more efficiently, ultimately using less energy.

• LED indicators for pressure, power, cup and temperature allow faster troubleshooting.

• Starts without high-frequency so it will not interfere with or damage controls or computers.

• Blow Back Torch Design The plasma arc is created by pulling an electrical arc between an electrode and tip. This process eliminates high frequency by forcing an electrical arc between the two pieces.

• Post Flow Cooling Circuit Protection to extend the life of consumables and the welding torch is enhanced by our post flow circuit that provides shielding gas after you release the trigger.

Detailed specs for Miller Spectrum 375 Plasma Cutter, 115/230 V, 60 Hz

• 1/16 in Stand off Cutting...Drag Cutting
• Rated: 3/8 in (10mm)... 5/16 in (8mm)
• Quality: 1/2 in (13mm) ... 3/8 in (10mm)
• Sever: 5/8 in (16mm)... 1/2 in (13mm)

• 115 - 230 V 1 Phase

• A 120 volt, 20 amp (min.) - 30 amp recommended or 230 volt, 15 amp (min.) individual branch circuit

• 4.5 CFM (129 L/min.) at 90 PSI (621 kPa)

• 27 A at 90 VDC, 35% Duty Cycle

• with torch: 55 lb (25 kg)

Miller Spectrum 375 Plasma Cutter, 115/230 V, 60 Hz comes complete with:

Resources for Miller Spectrum 375 Plasma Cutter, 115/230 V, 60 Hz