Miller - (907169)

• Plasma Cutter
• ICE-12 C hand-held torch with 20 ft (6.1 m) cable
• Heavy-duty work clamp with 20 ft (6.1 m) cable
• 10 ft (3 m) power cord
• Extra consumables (2 electrodes, 2 tips)

• A built-in, heavy-duty compressor makes this a cut-as-you-go machine anywhere power is available.

• Built-in, heavy-duty industrial piston-driven compressor provides long life and superior airflow.

• Solid-state, constant-current design offers consistent 12 amp cutting arc for continuous quality cutting up to 3/16 in steel in steel.

• Electronic Pilot Arc Controller automatically controls the pilot circuit to provide expanded metal cutting ability without having to re-trigger the torch, increasing productivity and extending tip life.

• LVC™ line voltage compensation provides peak performance power under variable conditions (98 to 132 volts) for steady cuts and cleaner ending cuts.

• Can be powered by any Miller engine drive with generator power (e.g. Bobcat™) or equivalent competitive equipment. See Spec Sheet for kW requirements.

• 35% duty cycle is tested at 40° C (104° F) to give you the cutting power whenever you need it.

• Starts without high-frequency so it will not interfere with or damage controls or computer.

• Blow Back Torch Design The plasma arc is created by pulling an electrical arc between an electrode and tip. This process eliminates high frequency by forcing an electrical arc between the two pieces.

• Post Flow Cooling Circuit Protection to extend the life of consumables and the welding torch is enhanced by our post flow circuit that provides shielding gas after you release the trigger.

Detailed specs for Miller

• Rated: 1/8 in (3.2 mm)
• Quality: 3/16 in (4.2 mm)

• 115 V 1 Phase

• A 120 volt, 20 amp individual branch circuit.

• 12 A at 110 VDC, 35% duty cycle

• 115V Model with torch: - 50 lb (22.7 kg)

Resources for Miller