Welding Project: Weld Your Own Bar

Whether you’re done with work and you want to relax with some friends at home or
to put together a memorable party on the weekend, you don’t need a ton of
money to buy a huge, fancy bar for your drinks. You just need a welder—a welder,
some 1 x 1 inch square steel tubing, and whatever you want to use for your
counter top and front facing of the bar.

Image: Lincoln
Electric

One welder put together an impressive
bar
that he built using a MIG welder. You could use a bar like this in your
basement when you entertain or in your kitchen as an island with plenty of
storage. Here are some steps for building your own bar.


Welding a Frame for Your Bar Welding Project

The frame for this bar is 1 x 1 inch steel tube that has been welded into two
simple rectangular frames which were then welded together. There’s not too much
to say other than you’ll need to clean your metal before welding, measure your
sides, and then tack weld each piece together using clamps to ensure that all of
your sides are flush.

Once you’re tacked together, finish your welds, grind them so that they’re
smooth and flush, and then decide whether you want to put any paint on the
metal. Chances are you’ll be putting some kind of facing on the bar and you
won’t need to worry about the metal being presentable.


Finishing Your Bar Welding Project

After the frame was welded together on the example above, it was wrapped on
three sides with corrugated metal and then finished along the bottom with wood
trim. You could just as well use paneling or another kind of metal, just keep in
mind that corrugated metal tends to be relatively light compared to some of the
other materials you could use.

One of the advantages of putting some kind of material around three sides of
the bar is that you can then add shelves below the counter top for storage.
Whether you put the bar in your kitchen or in another room of your home, a
little extra storage can be a great use of space and can even accommodate a mini
fridge if you build up enough support for it.

This project in particular has a 30 x 72 inch stainless steel top with a
1 inch rolled edge that serves as the counter, but you could just as well use
hard wood or any other durable material.


Find More Welding Projects

Baker’s Gas and Welding has plenty of welding projects for both beginner and
advanced welders.

Find another
welding project today.

Find the
best welder for you.

Leave a Reply

Your email address will not be published. Required fields are marked *